Cold-Knife Roll-to-Sheet Cutting Machine for Foam and Film, 700 mm WM-5270

The WM-5270 is a fully automatic roll-to-sheet cutting machine for foam, bubble film, plastic film, webbing, insulation paper and thin foils up to 700 mm wide. Type any length from 1 to 99,999 mm on the keypad and it feeds, cuts and counts at up to 150 pieces per minute with 0.1 mm accuracy. The blade is a cold knife, so foam and film edges come out clean instead of melted. It runs on 110 V or 220 V, 50/60 Hz, and ships with the unwind cradle and outfeed table shown in the photos.

Specifications

Key features

• Unwind cradle, powered feed rollers, cold knife and outfeed table in one frame — a roll goes in at one end, cut-to-length sheets land on the table at the other
• Cut length typed on the keypad, from 1 mm strips to sheets just short of 100 m — the same machine covers gasket pads and full-length film liners
• Cold blade leaves foam and film edges pressed clean, not melted — no scorch marks, no fused layers, no fumes at the workbench
• Runs up to 150 cuts per minute while the display keeps a live piece count, so batch quantities are read off the screen instead of counted by hand
• 700 mm working width takes wide foam and film rolls as well as narrow tapes and sleeving on the same roller path

What it processes

• Cutting foam and bubble-film pads to size for wrapping finished wire harnesses before boxing
• Cutting protective sleeving and heat shrink tubing into repeat lengths ahead of harness assembly
• Sheeting insulation paper and copper foil for transformer, coil and busbar work
• Producing repeat-length film and liner sheets for packing stations

Suited for: turning roll stock into accurately repeated lengths — foam, bubble film, plastic film, webbing, insulation paper and thin foils, any width up to 700 mm, at up to 150 pieces per minute with the count on the display. For other jobs and machine options: rigid pipe, thick-wall tube, or synthetic webbing that needs a heat-sealed edge — the WM-5270 cuts cold by design. For sealed edges, pick the WM-568 hot cutting machine, the hot-blade partner to this cold-cut sheeter; pipe and tube run on the rest of the tube and pipe cutting machines in this category.

Send us one roll of your actual material and your cut lengths — we run them on this machine on camera, so you see your own parts cut and stacked before you order. For a WM-5270 quote, start with your webbing, tape or strip width and the finish you need at the cut edge. If the end has to be sealed or cut to a shape, include a photo or sketch.