Selection guide
How to Measure Output on a PTFE Thread Tape Wrapping Machine
Use accepted fittings per hour to compare hand taping, a bench wrapper and a bowl-fed machine on the same job.
Technical lead: Lao Xiaoyu (劳晓宇) · Senior Engineer
Content updated:
Compare a PTFE thread tape wrapping machine with your current station using accepted fittings per elapsed hour. The WM-469 lists a 3–5 second cycle under a 2–3 turn reference and a published output of 600–800 fittings/hour. A sample run establishes what your parts, operators and inspection process can sustain.
Time a complete batch on the same basis
Choose a representative fitting and the same tape, acceptance rules and batch size for both methods. Record the elapsed time from getting the first fitting ready to the last accepted part. Include loading, removal, routine stops, rejects and any inspection carried out as part of the station. Use separate timestamps for setup, tape-roll changes and first-piece checks so you can see what uses the time.
Accepted fittings per hour = accepted fittings × 60 ÷ elapsed minutes. For example, 90 pieces passing inspection in a 12-minute trial gives 450 accepted fittings/hour. This is a calculation example. For a reliable shift plan, repeat the test across the actual mix of part numbers and use the time spent on changeovers.
| Question for a quote | Measurement |
|---|---|
| Does the bench wrapper speed up the work? | Accepted fittings/hour for the same fitting and operator handling |
| What happens when the part changes? | Last accepted part from the old job to first accepted part of the new job |
| Will bulk feeding save labor? | Operator time spent replenishing, tending and inspecting, plus accepted output with the same criteria |
Where the WM-469 fits
Use the WM-469 when an operator will continue to present and remove fittings and the repeated wrapping and cutting can be assigned to the machine. A bowl-fed WM-461 is another route when one part family runs for longer batches. Test the actual orientation and quote the fixtures required for every part in the mix. The machine selection guide includes a demonstration of repeated manual loading on the WM-469.
Request a timed trial for your fittings. Include typical lot sizes and the changeovers per shift. Use the sample acceptance checklist to define which pieces count.
Questions engineers ask
Is 600–800 fittings per hour guaranteed for my part?
It is the published WM-469 reference. Measure accepted parts per elapsed hour with your fittings, tape, loading, inspection and routine stops.
How do I count changeover time?
Record the interval from the last accepted fitting of the old job to the first accepted fitting of the new job. Include tape replacement, setup and the first-piece check.