🌐 English ▾

Troubleshooting guide

PTFE Thread Seal Tape Wrap Quality: How to Approve a Fitting Sample

Check tape coverage, setback, tail and assembly fit before approving a pipe-fitting tape wrapping machine.

Technical lead: Lao Xiaoyu (劳晓宇) · Senior Engineer
Content updated:

After wrapping, the operator turns the fitting so you can see the taped area and the open end.

Approve tape placement on the fitting, then approve the assembled joint. A sample from the WM-469 lets you inspect where the tape starts and ends, how it lies on the male thread and whether the tail stays down. Use the actual mating components and the assembly and leak-test criteria specified for your joint.

Check the wrap against an approved sample

InspectWhat to record
Setback from the fitting endThe approved start line, clear port and any exposed lead threads required by the joint instructions
CoverageTape within the agreed band, with no unintended bare patch, wrinkle or overlap onto a sealing face
TailThe cut end sits flat and stays in place after normal handling and packing
AssemblyEngagement and fit with the actual mate, plus the agreed leak-test result

In the close-up a metal fitting is removed and turned to show the wrapped zone and open end. Use that viewing angle when you request photos of your own samples. A camera can show coverage and finish. The functional test uses an assembled joint.

Separate setup settings from the acceptance criteria

The WM-469 allows you to set winding speed and turns. Select a tape and setting with the approved specifications for the joint and the production sample. Keep a first-off reference labeled with the fitting part number and the tape lot. Repeat the check after changing the tape roll or changing part number. When a joint seals at an O-ring or another separate face, confirm the joint’s requirements before taping its thread.

Request sample wraps on your actual fittings. Include the mating part or drawing, the tape specification and a photo of an acceptable wrap if you have one. For feed decisions and test time, see our machine selection guide and output measurement guide.

Questions engineers ask

How many turns of PTFE tape should I specify?

Use the tape and fitting suppliers’ approved instructions and verify the setting on the actual joint. The 2–3 turns in the WM-469 speed reference describe the cited machine cycle.

Can I approve sealing from a video of the wrap?

Use the video for visible features such as coverage and tail condition. Confirm functional sealing through the specified assembly and leak-test procedure.

👋 Need help choosing a machine? Ask me about specifications, processes and sample trials.
Email
Wiro — Equipment Assistant Equipment guidance · quotation team replies within 12 h