Selection guide
Split Loom Tubing: Cutting and Slitting vs Wire Harness Insertion
Choose the machine for the missing step in split loom assembly. Compare conduit cutting and lengthwise slitting with fitting the loom to a terminated harness.
Technical lead: Lao Xiaoyu (劳晓宇) · Senior Engineer
Content updated:
A split loom cutter prepares the tubing, while a wire loom insertion machine fits it around the cable bundle. For a harness that already has connectors at both ends, pre-slit tubing can go on from the side. Decide whether you need sleeves cut from a coil, sleeves fitted to a harness, or both steps.
Choose the station by what comes in and what goes out
| Material arriving at the station | Finished result | Wiromac model to evaluate |
|---|---|---|
| Corrugated tubing from an existing coil supply | Pieces cut to length and slit down the side | WM-605 cutter and slitter, specified for Ø5–30 mm. The separate coil payoff is outside this configuration. |
| Corrugated tubing on a coil that needs a powered feed | Cut and slit pieces from a two-unit set | WM-583 cutter and powered feeder, specified for Ø5–60 mm. |
| Split tubing and a wire bundle at the assembly bench | Tubing fitted around the bundle | WM-6118 loom insertion machine, specified for Ø4–35 mm tubing in the standard configuration. The video shows how the guide feeds the tube around the wires. |
A job using Ø40 mm tubing could fall within the WM-583 cutting range while requiring a custom WM-6118 insertion configuration. We offer custom insertion configurations for Ø35–50 mm. Use the same sample for both checks, since tube diameter alone does not establish guide clearance or usable space inside the loom.
Trial the hardest harness in your production mix
Send the actual tubing with its profile, OD, wall thickness, slit and required cut length. Show the thickest point of the bundle, including any wrap or splice, and include the production connectors. Mark where loom coverage starts and stops. For a branch, specify whether the loom stops short of the junction or uses a separate sleeve or fitting.
Seat the sample in the actual clips or fixtures and bend it through the intended route. Check whether the slit opens far enough to expose or trap wires, and whether a cut edge presses against the insulation. Confirm that connectors still seat fully and that all branch legs remain accessible. If a printed mark or clip sets the seam position, include that orientation in the trial.
Request a split loom machine quote. Tell us what arrives at the station and what the operator should hand to the next station. We can review the cut pieces, the fitted harness and the time for each operation.
See the process in action
Demonstrations from the machines referenced in this guide. Click to watch the operation, then request a trial with your own material.
Questions engineers ask
Does a split loom cutter install tubing on the harness?
A cut-and-slit machine prepares tubing pieces. An insertion machine fits the loom around the bundle. If you purchase pre-cut split pieces, evaluate insertion directly.
What should I provide for a split loom insertion trial?
Send production tubing and a fully representative harness with its largest bundle section, connectors, branches and required coverage length. Mark the position of the seam and the nearest bend.