Selection guide
Solar PV Cable Cutting and Stripping for EN 50618 and UL 4703
Qualify a cut-and-strip setup for 4, 6 or 10 mm² solar PV cable by insulation construction, long-lead repeatability, connector fit and sample inspection.
Technical lead: Lao Xiaoyu (劳晓宇) · Senior Engineer
Content updated:
For 4, 6 or 10 mm² photovoltaic cable, choose a cut-and-strip machine by the actual cable construction and the finished-end drawing. Record the cable standard, measured outside diameter and both strip lengths. Qualify the machine at your shortest and longest production lengths, then verify conductor condition and connector fit on finished samples.
What the PV cable marking tells you
UL Solutions’ PV cable testing guide identifies EN 50618 and UL 4703 as cable standards used for photovoltaic applications. Start with the exact approved cable and its datasheet. Even if two orders have the same nominal conductor size, the cable OD, jacket construction and cutting response can differ. The connector drawing controls its own strip length and contact preparation.
| Cable in your quote | What to measure or verify |
|---|---|
| 4 mm² string or extension lead | Measure the cable OD and check the stripped end with the exact terminal. Run the shortest and longest lengths used on the line. |
| 6 mm² cable from a different reel or cable family | Check jacket and insulation removal again. Use the actual roll during the trial so reel tension and cable memory are present. |
| 10 mm² cable | Match the cable OD to the machine and verify the connector or lug approval for the exact wire. Set up separate termination tooling when the connection drawing calls for it. |
Compare integrated and separate machines
Our WM-194 cut-and-strip machine has a published conductor range of 0.3–25 mm² and a programmed length range of 1–100,000 mm. Shortlist it when the job calls for cutting long leads and stripping both ends in one process. Confirm the blade and grip setup on your actual PV cable.
Where long leads are already cut, the WM-1216C pneumatic end stripper lists 0.5–25 mm² wire and a 3–50 mm strip-length range. Confirm the insulation response on a sample. For contact termination, separately evaluate an approved die and tool against the connector drawing. Our WM-3239 electric crimper can be evaluated for connections within its quoted tooling scope.
What to approve on a production sample
- Run the length mix from the intended reel and record the completed length without stretching the cable.
- Measure both strip lengths, then inspect the strands and the insulation edge after the slug comes off.
- Assemble with the specified contact and connector. Check insertion and use the connection’s required crimp and pull-test procedures.
- Time accepted pieces through cutting, stripping and inspection, including recipe changes. Use that count when sizing the production line.
Send us your PV cable marking and length range for a machine and tooling quote. For the downstream operations, see our solar PV cable assembly line guide.
See the process in action
Demonstrations from the machines referenced in this guide. Click to watch the operation, then request a trial with your own material.
Questions engineers ask
Can one setup cut and strip 4, 6 and 10 mm² PV wire?
Shortlist by the stated conductor range and cable outside diameter, then run each actual cable. Use the finished cut length, end-strip drawing and connector instructions to define the acceptance checks for each size.
Does EN 50618 or UL 4703 set the stripping length for the connector?
Use the exact connector's assembly instructions for the stripping length and contact tooling. Confirm the cable's standard, marking and cable part number against your purchasing requirements.