Selection guide
UL1007 and UL1015 Hook-Up Wire Cutting and Stripping Machines
Select reel-fed cut-and-strip equipment or a bench end stripper for AWM Style 1007 and 1015 wires using gauge, insulation OD and finished strip geometry.
Technical lead: Lao Xiaoyu (劳晓宇) · Senior Engineer
Content updated:
Choose a machine for AWM Style 1007 or 1015 hook-up wire by how the wire arrives and what the finished lead must look like. For reel-fed production, check the machine’s cut length and conductor range. For pre-cut leads, select an end stripper by strip length, conductor range, insulation OD and how the operator will hold the shortest lead.
What the wire style and AWG tell you
UL identifies Style 1007 and Style 1015 as AWM styles under UL 758. Use your approved wire part number and current datasheet to get the actual conductor construction, insulation OD and applicable recognition. A nominal AWG value is useful for matching the conductor to a machine range. The insulation diameter and thickness determine the practical tooling setup.
| Input | Use it to choose or set up the machine |
|---|---|
| Jacket marking and wire part number | Separate recipes by actual wire specification, including solid or stranded construction. |
| Nominal AWG and measured insulation OD | Use conductor area for the machine shortlist and OD for guide clearance and blade setup. |
| Cut length and head and tail strip lengths | Confirm that the machine can support the shortest lead, handle the longest one and produce both end preparations. |
| Finished lead sample or drawing | Define full or partial strip, permitted strand damage, length tolerance and whether a connector or splice follows. |
Choose the process for the required gauge
| Job | Wiromac candidate |
|---|---|
| Reel-fed single-core wire and repeated cut lengths | WM-167 lists 0.1–10 mm² and cut lengths from 1–9,999 mm. Confirm the small-gauge endpoint using the measured conductor and a sample. |
| Fine wire such as AWG 32 presented pre-cut | WM-1215C lists AWG 32–14, maximum OD of 3.2 mm and a 1–20 mm end strip. Test the finest sample for retained strands and feed or clamp marks. |
| Heavier pre-cut hook-up wire, such as an AWG 10 job | WM-1216C lists 0.5–25 mm² and 3–50 mm strip length. Use the actual cable OD, insulation and end geometry when qualifying the fit. |
Use the AWG-to-mm² calculator to convert the nominal conductor size while preparing the quotation. For a mixed wire set, trial the smallest conductor and the thickest insulation first, then time accepted parts through changeover and inspection. Ask us to quote a hook-up wire cut-and-strip setup with a wire marking, cut length or finished lead photo.
See the process in action
Demonstrations from the machines referenced in this guide. Click to watch the operation, then request a trial with your own material.
Questions engineers ask
Can UL1007 and UL1015 wires of the same AWG share a stripping recipe?
Check both wires' insulation outside diameter and construction, then verify the finished strip on both materials. AWG identifies the conductor size and does not establish the blade depth or feed setting.
Which machine should I consider for 32 AWG wire?
For fine pre-cut wire, the WM-1215C end stripper is a candidate within its listed size range. For reel-fed cut-to-length work, use the measured conductor and insulation dimensions and validate the fine end in a trial.