Selection guide
135.8 mm Shut Height Crimping Press Guide: Reusing Existing Applicators
Compare a new bench press and applicator package with a tooling reuse quote by checking shut height, base and ram interfaces, stroke and first-piece results.
Technical lead: Lao Xiaoyu (劳晓宇) · Senior Engineer
Content updated:
A 135.8 mm shut-height requirement is the first line of a press reuse inquiry. To reuse an existing applicator, confirm the specified measuring surfaces, base and ram fit, working stroke, feed actuation and guarding. Obtain the proposed setup in writing and qualify it on production wire and terminals before committing to a tooling reuse quote.
Read the actual applicator documentation
The Molex FA2 manual specifies 135.8 mm shut height for that family and also describes the mounting and ram interface. The JST application tooling guide lists an industry-standard applicator at 135.78 mm and a separate 160 mm press and applicator family. Quote the exact drawing and its tolerances for your tooling. See how shut height, ram travel and finished crimp height differ.
| Quote requirement | Evidence to obtain before purchase |
|---|---|
| Closed height and usable stroke | Dimensioned interface drawing, approved gauging procedure and confirmation of feed timing through the full stroke |
| Base and ram connection | Dimensioned mounting and locating geometry, including any adapter or change required by the quoted setup |
| Terminal presentation | Carrier pitch and direction, actuation type and clearance for the reel, track and scrap |
| Workstation and first pieces | Guarding and operator access, plus measurements of finished parts against your application specification |
Compare two routes for the same job
- Reuse the existing applicator. Ask for a press configuration matched to its tooling identity. Include approved adapters or setup work, worn tooling replacement, inspection and changeover time.
- Order a matched press and applicator. Ask for a quote that names the tooling for every terminal family, including what ships with the first machine and what the next applicator costs. Compare this route with reuse on the same installation and trial basis.
Our WM-3102T bench press lists several OTP and 2000# applicator families. The WM-3102S servo press lists 20 kN force. Both list 30 mm standard stroke and a 40 mm custom option. Ask us to confirm the requested shut-height interface in writing for the exact press and applicator before ordering.
Once the fit is confirmed, run first pieces with the production terminal and wire. Record crimp height and connection appearance, then perform pull or cross-section checks where required. Ask for reuse and matched-tooling quotations using the applicator identifier, terminal reference and mounting drawing.
See the process in action
Demonstrations from the machines referenced in this guide. Click to watch the operation, then request a trial with your own material.
Questions engineers ask
Will a 135.8 mm shut-height applicator fit a new crimping press?
Start with the dimension and its specified reference surfaces, then check base and ram interfaces, stroke, feed actuation, clearance and guarding. Obtain written confirmation for the exact press and applicator pair before purchase.
How should I compare the cost of reusing a crimp applicator?
Ask for one quote covering verified reuse and one covering a matched press and applicator. Include any approved interface work, setup, inspection, replacement parts and the cost of each required tooling family.