🌐 English ▾

Selection guide

Paper Core Cutting Machine Selection: ID, OD and Finished Width

Use the bore, outside diameter, wall and finished width to compare paper core cutters. Check the cut edge and run the core on your winding shaft.

Technical lead: Lao Xiaoyu (劳晓宇) · Senior Engineer
Content updated:

Choose a paper core cutting machine using the inside diameter (ID), outside diameter (OD), wall thickness and length of the uncut tube. Specify the finished core width separately. The bore must fit your winding shaft or chuck, and the finished width must fit the roll you are making.

Measure the parent tube and the finished core

For a paper core specified at 3 inches ID, the bore is 76.2 mm. A uniform 6 mm wall gives a nominal OD of 88.2 mm (76.2 + 2 × 6). Measure the actual tube before ordering. If the opening is out of round, a single diameter reading can hide the tight point. Take readings across more than one axis and include the coating or liner in the sample.

What you sendWhat it helps us check
Actual ID, OD, wall and paper constructionChuck or support fit, clearance and cut through the wall
Parent tube length and finished axial widthsLoading setup, usable cutting length and the cut list
Width tolerance, mating shaft and acceptable edge sampleWhich pieces pass inspection and fit the next operation

Compare WM-613 and WM-615 where the ranges overlap

ConfigurationSpecified diameterTube cutting lengthWall thickness
WM-61325–200 mm<1,310 mm1–18 mm
WM-615 large-diameter configuration140–320 mm<1,610 mm1–15 mm

We confirm which diameter the listed range applies to and match the tooling on the quote. For instance, if a job falls in the overlap after that check, a 16 mm wall points to WM-613 within its length range. A 1,450 mm cutting length calls for WM-615 within its wall range. Check the dimensions together before shortlisting.

Approve a cut core on the winding shaft

Measure finished width at several points around the rim. A wide spread can reveal a cut face that sits unevenly against another core. Inspect the bore for raised paper and both edges for lifted plies or crushing. Then slide the sample onto the shaft or chuck used in production, seat it against its stop and check how it runs. Time a representative batch through loading, cutting, unloading and inspection. Use accepted cores per hour when comparing quotes.

Request a paper core cutting quote. Share the measured bore, OD, wall, parent tube length and your list of finished widths. The machine page shows a cutting run and measured samples.

See the process in action

Demonstrations from the machines referenced in this guide. Click to watch the operation, then request a trial with your own material.

Questions engineers ask

Is a 3-inch paper core 76.2 mm across the outside?

If 3 inches is the specified inside diameter, the bore is 76.2 mm. With a uniform 6 mm wall, the nominal outside diameter would be 88.2 mm. Send both measured diameters.

How do I compare paper core cutters when both cover the same diameter?

Check wall thickness, cutting length and the chuck fit. Time the same job from loading through unloading and count cores that meet width and fit requirements.

👋 Need help choosing a machine? Ask me about specifications, processes and sample trials.
Email
Wiro — Equipment Assistant Equipment guidance · quotation team replies within 12 h